Washer Repair: 4 Reasons Why Your Washing Machine is Overflowing

Washer Repair Service of El Paso discuss why your washer is leaking.

Throwing a load of laundry into your washing machine is a modern convenience many of us take for granted, but when that wonderful appliance decides to overflow the inconvenience can create some intense hair-pulling moments. Diagnosing why your washer has suddenly decided to flood your laundry room can ease your anxiety and speed up the repair process. The following 4 troubleshooting tips are common reasons why you are finding puddles on the floor near your appliance.

• A common malfunction that causes washer machines to overflow is a defective water inlet valve. The inlet valve is located on the outside of the washer machine, and it is what attaches your homes water line to the washer. At the beginning of a wash cycle, the inlet valve allows water to enter the appliance’s tank and turns off once the water level sensor indicates the proper amount of water is achieved. If the valve is faulty, it will not react to the sensor’s signal and will continue to fill the tank, resulting in an overflowing washing machine. The only way to repair this problem is by replacing the defective part.
• Poor water pressure running to your inlet valve is another reason why your washer could be overflowing. When the water pressure is too low, the valve may not close properly, which translates into a leak. The constant leak can cause your washer to overflow.
• Your washer machine has a timer control that does not allow it to begin spinning before it’s tank is completely drained of water. When the timer is broken or needs to be reset, your appliance may start the spin cycle before the tank is empty causing water to splash out of your machine. If you suspect your washer is experiencing this malfunction, a call to a washer repair company can help you fix the problem.
• All washer machines have a pressure switch. The switch is activated when the air pressure in a tube located on the outside of the washer tub rises to a certain level. The buildup of pressure indicates when the water flow needs to be turned off. In cases where the tube is clogged, or there is a hole located in it, the air pressure will not reach the appropriate level to switch off the inlet valve. Unclogging the plastic tube or replacing it will stop your washer from overflowing.

If you’re dealing with the headache of an overflowing washer, please contact us at SoBellas Home Services El Paso Appliance Repair. We have served over 35,000 customers in the last 37 years, and we would be happy to assist you with your appliance repair needs.

Washer Repair El Paso compared to the Hubble Telescope.

Unlike the article on Huffington Post, “A Washing Machine Should Last As Long as Hubble Telescope, ”those top or front-loading washers are simply not made to last an eternity. Keep ahead of Washer Repair with these tips:

Don’t fill it to the brim. Have you ever wondered why it is you can’t overload your washer, stuffing full to the brim? It has to do with the stress on the belt motor. The belt can slip or even break with load after load overloaded. The repair could be more costly than a few extra washes at recommended load levels.

Soap, Soap everywhere… Some of the newer washers may not drain right because of the suds if you use too much detergent. Front-end washers will probably leak if you add too much soap as the suds can rise too high up in the overflow tube—sometimes this will cause the machine to stop as well.

It’s about protecting the finish: Don’t spray pre-wash on top of your washer. True, while most of the coatings on washing machines are Porcelain Enamel, using today’s pre-wash or stain removers can, over time,” do a number on the “painted and plastic surfaces.”

Don’t neglect the ‘fill hose screens’ Just like your car engine, the washing machine has to breath. That means cleaning the intake screens—they’re located where the water hoses enter the machine. Sediment can build up, as well as mineral deposits.

Go gently when removing hoses to protect the threads on the back of your unit. Rubber hoses last about five years, while the braided kind should last twice as long. If you have any questions about washer repair, please feel free to contact us in El Paso.